openscad/repjack-test.scad

   1 module pagoda(scale=1, height=1, ratio=2, center=true) {
   2         scale([scale,scale])
   3         linear_extrude(height=height, center=center)
   4         polygon(points=[[-1,1],[1,1],[1*ratio,-1],[-1*ratio,-1]], paths=[[0,1,2,3]]);
   5 }
   6
   7 module female(thickness=0.3) {
   8         difference() {
   9                 %cube([4,2+thickness,1+(2*thickness)], center=true);
  10                 translate([0,thickness,0]) pagoda(ratio=1.5);
  11         }
  12 }
  13
  14 module male() {
  15         difference() {
  16                 pagoda(ratio=2, scale=0.9);
  17                 //translate([0,-0.7]) pagoda(ratio=2);
  18                 translate([0,-0.21]) pagoda(ratio=2, scale=0.7, height=1.1);
  19         }
  20 }
  21
  22 module connector(design=false) {
  23         scale(4) if(!design) {
  24                 //Print
  25                 translate([0,3,0-1.15+0.5]) male();
  26                 rotate([90]) female();
  27         } else {
  28                 //Design
  29                 male();
  30                 % female();
  31         }
  32 }
  33
  34 //connector(design=true);
  35 connector();