--- /dev/null
+/*
+ * Blink
+ *
+ * The basic Arduino example. Turns on an LED on for one second,
+ * then off for one second, and so on... We use pin 13 because,
+ * depending on your Arduino board, it has either a built-in LED
+ * or a built-in resistor so that you need only an LED.
+ *
+ * http://www.arduino.cc/en/Tutorial/Blink
+ */
+
+int Pin = 13; // LED connected to digital pin 13
+int
+
+void setup() // run once, when the sketch starts
+{
+ pinMode(Pin, OUTPUT); // sets the digital pin as output
+}
+
+void loop() // run over and over again
+{
+ delay(1);
+ digitalWrite(Pin, HIGH); // sets the LED onv
+ digitalWrite(Pin, LOW); // sets the LED offv
+}