4 * The basic Arduino example. Turns on an LED on for one second,
5 * then off for one second, and so on... We use pin 13 because,
6 * depending on your Arduino board, it has either a built-in LED
7 * or a built-in resistor so that you need only an LED.
9 * http://www.arduino.cc/en/Tutorial/Blink
12 int Pin = 13; // LED connected to digital pin 13
15 void setup() // run once, when the sketch starts
17 pinMode(Pin, OUTPUT); // sets the digital pin as output
20 void loop() // run over and over again
23 digitalWrite(Pin, HIGH); // sets the LED onv
24 digitalWrite(Pin, LOW); // sets the LED offv